The slab is designed as one way if the ratio of long span to short span is_____________?
(A) less than 1
(B) between 1 and 1.5
(C) between 1.5 and 2
(D) greater than 2
In reinforced concrete footing on soil, the minimum thickness at edge should not be less than______________?
(A) 100 mm
(B) 150 mm
(C) 200 mm
(D) 250 mm
Minimum thickness of load bearing RCC wall should be_____________?
(A) 50 mm
(B) 100 mm
(C) 150 mm
(D) 200 mm
A continuous beam is deemed to be a deep beam when the ratio of effective span to overall depth (1/D. is less than__________________?
(A) 1.5
(B) 2.0
(C) 2.5
(D) 3.0
Minimum pitch of transverse reinforcement in a column is________________?
(A) the least lateral dimension of the member
(B) sixteen times the smallest diameter of longitudinal reinforcement bar to be tied
(C) forty-eight times the diameter of transverse reinforcement
(D) lesser of the above three values
Maximum percentage reinforcement in case of slabs is limited to___________________?
(A) 2
(B) 4
(C) 6
(D) 8
The minimum cover to the ties or spirals should not be less than________________?
(A) 15 mm
(B) 20 mm
(C) 25 mm
(D) 50mm
The limits of percentage p of the longitudinal reinforce-ment in a column is given by_____________?
(A) 0.15% to 2%
(B) 0.8% to 4%
(C) 0.8% to 6%
(D) 0.8% to 8%
The main reason for providing number of reinforcing bars at a support in a simply supported beam is to resist in that zone_________________?
(A) compressive stress
(B) shear stress
(C) bond stress
(D) tensile stress
When shear stress exceeds the permissible limit in a slab, then it is reduced by____________?
(A) increasing the depth
(B) providing shear reinforcement
(C) using high strength steel
(D) using thinner bars but more in number