Chemical Engineering Mcqs

Addition of lead, sulphur and phosphorus to low carbon steel helps in improving its__________________?

(A) Corrosion resistance

(B) Tensile strength

(C) Machinability

(D) Compressive strength

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • A 6 V battery output is divided down to obtain two output voltages. Three 2.2 kΩ resistors are used to provide the two taps. The two output voltages are___________?
  • The internal resistance of a 20,000 ohm/volt voltmeter set on its 5 V range is_____________?
  • A certain voltage divider consists of three 1 kΩ resistors in series. Which of the following load resistors will have the least effect on the output voltage?
  • Two 1.2 kΩ resistors are in series and this series combination is in parallel with a 3.3 kΩ resistor. The total resistance is____________?
  • A certain voltage divider consists of two 12 kΩ resistors in series. Which of the following load resistors will have the most effect on the output voltage?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON