Chemical Engineering Mcqs

In cold working of metal as compared to its hot working____________________?

(A) Cracks and blow holes are eliminated

(B) Ductility and impact strength improves

(C) Appreciable strain hardening is produced

(D) Yield stress, hardness and fatigue strength is not at all affected

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • In a series–parallel circuit consisting of R1 and R2 in series and connected in parallel with R3, if R1 opens, then R2‘s voltage will:___________?
  • In a series resonant band-pass filter, a lower value of Q results in______________?
  • The maximum output voltage of a certain low-pass filter is 15 V. The output voltage at the critical frequency is_____________?
  • The same signal in Problem 2 is applied to an RC high-pass filter. If the reactance is zero at the input frequency, the output voltage is____________?
  • A sinusoidal voltage with a peak-to-peak value of 18 V is applied to an RC low-pass filter. If the reactance at the input frequency is zero, the output voltage is____________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON