Chemical Engineering Mcqs

In the design of a shell and tube heat exchanger, the corrosion allowance ____________________?

(A) Need not be provided for non-pressure parts like tie rods, spacers, baffles, supports etc.

(B) For carbon steel and cast iron pressure parts is 1.5 mm (except for tubes) and for severe conditions it is 3 mm

(C) For internal cover and tube sheet is provided on both the sides

(D) All

Submitted By: Ali Uppal


Share this... Share on Facebook
Facebook
Tweet about this on Twitter
Twitter
Share on LinkedIn
Linkedin
Share on Whatsapp
Whatsapp

  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

  • Related Mcqs


    Leave a Reply

    Your email address will not be published. Required fields are marked *