Chemical Engineering Mcqs

Multipass heat exchangers are used______________________?

(A) Because of simplicity of fabrication

(B) For low heat load

(C) To obtain higher heat transfer co-efficient and shorter tube

(D) To reduce the pressure drop

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • The Young’s modulus of elasticity of steel, is__________________?
  • If the tendon is placed at an rectangular beam (sectional top edge)________________?
  • If the length of a combined footing for two columns l metres apart is L and the projection on the left side of the exterior column is x, then the projection y on the right side of the exterior column, in order to have a uniformly distributed load, is (where is the distance of centre of gravity of column loads______________?
  • If the loading on a pre-stressed rectangular beam, is uniformly distributed, the tendon to be provided should be_______________?
  • The maximum ratio of span to depth of a slab simply supported and spanning in two directions, is_________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON