Chemical Engineering Mcqs

Plastic articles are normally produced by _____________ moulding?

(A) Green sand

(B) Injection

(C) Shell

(D) Dry sand

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • A and B are two towers of equal height diametrically opposite on either side of the nadir point, at 3 km and 5 km distances. Which one of the following statements is correct?
  • Which one of the following residual biases involves the GPS accuracy ?
  • Critical angle of electromagnetic radiation takes place if__________________?
  • Spatial variation in horizontal and vertical directions is caused due to_________________?
  • If electric permittivity and magnetic permeability of the medium are respectively and , then the velocity (Cm) of the electromagnetic wave in the medium is given by___________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON