Chemical Engineering Mcqs

The reason for excessive clinker formation in gas producers is the_____________________?

(A) Use of coal/coke containing a high % of fines and ash

(B) Use of fuel having too low an ash fusion temperature

(C) Development of hot spots in the fuel bed and an abnormally high rate of gasification

(D) All

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • In a 3-phase power measurement by two wattmeter method, both the watt meters had identical readings. The power factor of the load was___________?
  • Which of the following is an essential part of a motor meter ?
  • In a low power factor wattmeter the compensating coil is connected_______________?
  • The multiplier and the meter coil in a voltmeter are in________________?
  • For measuring current at high frequency we should use_______________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON