Chemical Engineering Mcqs

Width and depth of grooves in the tube sheet holes normally are _______________ inch respectively?

(A) 1/8 and 1/64

(B) 1/64 and 1/8

(C) 1/2 and 8

(D) 1/2 and 5

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • The maximum propulsion efficiency of a turbojet is attained at around following speed __________________?
  • A rocket works with maximum overall efficiency when air craft velocity is equal to the_________________?
  • In the cross compounding of the gas turbine plant__________________?
  • Work ratio of a gas turbine plant is ratio of______________________?
  • In the aircraft propellers __________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON