Civil Engineering Mcqs

In a gusseted base, when the end of the column is machined for complete bearing on the base plate, then the axial load is assumed to be transferred to base plate__________________?

(A) fully by direct bearing

(B) fully through fastenings

(C) 50% by direct bearing and 50% through fastenings

(D) 75% by direct bearing and 25% through fastenings

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Calorific value of coke even gas produced by low temperature carbonisation of coal is about ____________ Kcal/Nm3?
  • Softening temperature of coal ash is a measure of the _____________ of coal?
  • A sample of natural gas containing 80% methane (CH4) and rest nitrogen (N2) is burnt with 20% excess air. With 80% of the combustibles producing CO2 and the remainder going to CO, the Orsat analysis in volume percent is_________________?
  • Higher fuel combustion efficiency cannot be achieved by_________________?
  • Tolerable concentration of toxic carbon monoxide in atmospheric air is about ______________ ppm?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON