Civil Engineering Mcqs

The depression of water table in a well due to pumping will be maximum_______________?

(A) at a distance R from the well

(B) close to the well

(C) at a distance R/2 from the well

(D) none of the above where R is the radius of influence

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Diaphragm pumps are used to transport_________________?
  • The length of the tube necessary for the boundary layer to reach the centre of the tube and for fully developed flow to be established is called the _____________ length?
  • With decrease in particle size to be fluidised by a particular fluid, the operating range of fluidisation velocity___________________?
  • For very low pressure and high discharge rate, the compressor used is a/an ______________ compressor?
  • A bed of spherical particles (specific gravity 2.5) of uniform size 1500 μm is 0.5 m in diameter and 0.5 m high. In packed bed state, the porosity may be taken as 0.4. Ergun’s equation for the above fluid-particle system (in SI units) is given below : Δ P/L = 375 × 103 VOM + 10.94 × 106 V2 OM (SI units) If water is to be used as the fluidising medium, the minimum fluidisation velocity, VOM is_________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON