Mechanical Engineering Mcqs

In a typical medium speed 4-stroke cycle diesel engine________________?

(A) compression starts at 35° after bottom dead center and ends at top dead center

(B) compression starts at bottom dead center and ends at top dead center

(C) compression starts at 10° before bottom dead center and, ends just before top dead center

(D) may start and end anywhere

(E) none of the above

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Filtration rate through a filter cake is proportional to (where, S = filtering surface R = specific cake resistance μ = viscosity of the filtrate) ?
  • Kick’s law assumes that the energy required for size reduction is proportional to the logarithm of the ratio between the initial and the final diameters. The unit of Kick’s constant is_________________?
  • To get ultrafine particles, the equipment used is a _________________?
  • Tabling process used for separating two materials of different densities by passing the dilute pulp over a table/deck, which is inclined from the horizontal surface at an angle of about________________?
  • Tube mill compared to ball mill_______________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON