Mechanical Engineering Mcqs

PERT is the__________________?

(A) time oriented technique

(B) event oriented technique

(C) activity oriented technique

(D) target oriented technique

(E) work oriented technique

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • In saturated gas, the__________________?
  • Berl saddle made of carbon cannot be used for ___________________?
  • For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of _______________ microns (1 mm = 1000 microns)?
  • If G = insoluble gas in gas stream and L = non-volatile solvent in liquid stream, then the slope of the operating line for the absorber is___________________?
  • Corresponding to Prandtl number in heat transfer, the dimensionless group in mass transfer is the _______________ number?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON