Mechanical Engineering Mcqs

Taper on the cotter and slot is provided_________________?

(A) on both the sides

(B) on one side only

(C) on none of the sides

(D) may be provided anywhere

(E) none of the above

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Power required to drive a ball mill with a particular ball load is proportional to (where, D = diameter of ball mill.) ?
  • Which of the following is not a non-metalliferous mineral ?
  • A widely used size reduction equipment for ______________ is Bradford breaker?
  • The equivalent diameter of channel of a constant non-circular cross-section of 3 cm by 6 cm will be _______________ cms?
  • Colloid mills achieve size reduction mainly by___________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON