Software Engineering Mcqs

In which test design each input is tested at both ends of its valid range and just outside its valid range ?

(A) Boundary value testing

(B) Equivalence class partitioning

(C) Boundary value testing AN

(D) Equivalence class partitioning

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • If the field winding of an unloaded salient pole synchronous motor is open circuited, the motor will__________?
  • A synchronous machine with low value of short-circuit ratio has___________?
  • The maximum constant load torque under which a synchronous motor will pull into synchronism at rated rotor supply voltage and frequency is known as___________?
  • For similar carrier and modulating signals, the line current used in CSI is_____________?
  • During the commutation period in 3 phase converter, overlap time is____________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON