Chemical Engineering Mcqs

LMTD correction factor is used in heat exchanger design for____________________?

(A) Double pipe heat exchanger

(B) Multipass shell and tube heat exchanger

(C) Fouling fluids

(D) Counter flow of hot and cold fluids

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Tandem drawing of wires and tubes is necessary because_________________?
  • The shrinkage allowance for cast iron pattern is________________?
  • In spot welding, the spacing between two spot weld should not be less than _______________?
  • Lancing is the operation of _________________?
  • The cold working of metals is carried out_________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON