Mechanical Engineering Mcqs

Tandem drawing of wires and tubes is necessary because_________________?

(A) accuracy in dimensions is not possible otherwise

(B) surface finish improves after every drawing stage

(C) it is not possible to reduce at one stage

(D) annealing is needed between stages

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • LMTD correction factor is used in heat exchanger design for____________________?
  • A binary liquid Azeotropic mixture has boiling point higher than either of the components, when it shows ______________ deviation from Raoult’s Law?
  • Which tube arrangement in a heat exchanger would facilitate highest heat transfer rate ?
  • Cooling water fouling factors vary in the range of 0.001 to 0.003____________________?
  • A cylindrical storage tank can have a self supported conical roof ?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON