Mechanical Engineering Mcqs

Boiler parameters are expressed by ___________________?

(A) tonnes/hr. of steam

(B) pressure of steam in kg/cm2

(C) temperature of steam in °C

(D) all of the above

(D) none of the above

Submitted By: Ali Uppal


Calorific value of coal is of the order of _______________________?

(A) 200-400 kcal/kg

(B) 800-1200 kcal/kg

(C) 2000-4000 kcal/kg

(D) 5000-8000 kcal/kg

(D) 8000-10,000 kcal/kg

Submitted By: Ali Uppal


The condition of steam in boiler drum is always ___________________?

(A) dry

(B) wet

(C) saturated

(D) supersaturated

(D) superheated

Submitted By: Ali Uppal


Which device is used in thermal power plants to reduce level of pollution___________________?

(A) induced draft fan

(B) smoke meter

(C) chimney

(D) precipitator

(D) pulveriser

Submitted By: Ali Uppal


Spontaneous combustion is a phenomenon in which____________________?

(A) all the fuel burns instantaneously producing high energy release

(B) fuel burns with less air

(C) coal bursts into flame without any external ignition source but by itself due to gradual increase in temperature as a result of heat released by combination of oxygen with coal

(D) explosion in furnace

(D) none of the above

Submitted By: Ali Uppal


An economiser in a boiler______________________?

(A) increases steam pressure

(B) increases steam flow

(C) decreases fuel consumption

(D) decreases steam pressure

(D) increases life of boiler

Submitted By: Ali Uppal


Sulphur content of fuels is very important to the plant operators because it____________________?

(A) has high heating value

(B) retards electric precipitation

(C) promotes complete combustion

(D) has highly corrosive effect

(D) facilitates ash removal

Submitted By: Ali Uppal


Gusset stays in a boiler are provided to____________________?

(A) prevent the bulging of flat surfaces

(B) avoid explosion in furnace

(C) prevent leakage of hot flue gases

(D) support furnace freely from top

(D) prevent atmospheric air leaking into furnace

Submitted By: Ali Uppal


Pour point of fuel oil is the____________________?

(A) lowest temperature at which oil will flow under set condition

(B) storage temperature

(C) temperature at which fuel is pumped through burners

(D) temperature at which oil is transported

(D) none of the above

Submitted By: Ali Uppal


The behaviour of coal in a furnace is determained by_______________________?

(A) the content of sulphur

(B) the content of ash and heating value

(C) the proximate analysis

(D) the exact analysis

(D) its type

Submitted By: Ali Uppal