Chemical Engineering Mcqs

Fouling factor must be included in the calculation of overall design heat transfer coefficient, when the liquid__________________?

(A) Containing suspended solids flows at low velocity

(B) Containing suspended solids flows at high velocity

(C) Is highly viscous

(D) Is of high specific gravity

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • The volumetirc efficiency of a compressor is calculated on the basis of __________________?
  • For slow-speed large capacity compressor, following type of valve will be best suited________________?
  • The compressor efficiecny is the__________________?
  • For a compressor, least work will be done if the compression is________________ ?
  • To avoid moisture troubles, the branch connections from compressed air lines should be taken from_________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON