Chemical Engineering Mcqs

‘Fouling factor’ used in the design of a multipass shell and tube heat exchanger is a_____________________?

(A) Non-dimensional factor

(B) Factor of safety

(C) Conversion factor for individual film heat transfer co-efficient to overall heat transfer coefficient

(D) None of these

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Maximum percentage reinforcement in case of slabs is limited to___________________?
  • The minimum cover to the ties or spirals should not be less than________________?
  • The limits of percentage p of the longitudinal reinforce-ment in a column is given by_____________?
  • The main reason for providing number of reinforcing bars at a support in a simply supported beam is to resist in that zone_________________?
  • When shear stress exceeds the permissible limit in a slab, then it is reduced by____________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON