Chemical Engineering Mcqs

In the design of a shell and tube heat exchanger, the corrosion allowance ____________________?

(A) Need not be provided for non-pressure parts like tie rods, spacers, baffles, supports etc.

(B) For carbon steel and cast iron pressure parts is 1.5 mm (except for tubes) and for severe conditions it is 3 mm

(C) For internal cover and tube sheet is provided on both the sides

(D) All

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • The maximum compression ratio in an actual single stage axial flow comperssor is of the order of________________?
  • The pressure ratio for an open cycle gas turbine compared to closed cycle gas turbine of same h.p. is_______________?
  • Rotary compressors are suitable for ____________________?
  • Gas turbine works on______________?
  • Gas turbine works on_______________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON