Chemical Engineering Mcqs

Indirect contact heat exchangers are preferred over direct contact heat exchangers, because_________________?

(A) Heat transfer co-efficient are high

(B) There is no risk of contamination

(C) There is no mist formation

(D) Cost of equipment is lower

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • In a combined footing if shear stress exceeds 5 kg/cm2, the nominal stirrups provided are______________?
  • Based on punching shear consideration, the overall depth of a combined footing under a column A, is_______________?
  • The diameter of main bars in R.C.C. columns, shall not be less than________________?
  • An intermediate T-beam reinforced with two layers of tensile steel with clear cover 13 cm encasted with the floor of a hall 12 metres by 7 metres, is spaced at 3 metres from adjoining beams and if the width of the beam is 20 cm, the breadth of the flange is__________________?
  • The effective span of a simply supported slab, is_______________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON