Chemical Engineering Mcqs

Often earing defects are found during deep drawing operation, because the __________________?

(A) Surface finish of the sheet is poor

(B) Sheet material has been given substantial spring back

(C) Starting sheet has planer anisotropy due to its texture

(D) Starting sheet has normal anisotropy due to its texture

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Constituents of stellite are ____________________?
  • Which of the following pairs is not correctly matched ?
  • When dry bulb temperature & wet bulb temperature of moist air is the same, it means that the _________________?
  • Specific gravity of hot metal (pig iron) is ______________ times that of the blast furnace slag ?
  • What happens, when SO2 is passed through a solution of H2S in water ?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON