Chemical Engineering Mcqs

Pick out the wrong statement about routing of fluids in a shell and tube heat exchanger ?

(A) The corrosive and fouling fluid should be preferably routed through the tubes

(B) The viscous fluid should be routed through the shell side

(C) Lower flow rate fluid should be routed through the shell side

(D) Higher pressure fluid stream should be routed through the shell side

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Maximum work is done in compressing air when the compression is_________________?
  • The capacity of a compressor is 5 m /mih. 5 m /min refers to_______________?
  • Free air is the air at________________?
  • 1 m of air at atmospheric condition weighs approximately__________________?
  • Ratio of compression is the ratio of__________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON