Chemical Engineering Mcqs

Pick out the wrong statement pertaining to a shell and tube heat exchanger ?

(A) The minimum value of baffle spacing is 50 mm

(B) The maximum value of baffle spacing is equal to the I.D. of the shell

(C) The maximum unsupported tube span is generally about 75 times tube diameter, but is reduced to about 60 times for aluminium, copper & alloys of these

(D) Disk and doughnut baffle is the most commonly used baffle

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • For accurate work, the steel band should always be used in preference to chain because the steel band______________?
  • The maximum tolerance in a 20 m chain is_______________?
  • The length of a chain is measured from_______________?
  • If the true bearing of a line AB is 269° 30′, then the azimuth of the line AB is_____________?
  • For which of the following permanent adjustments of theodolite, the spire test is used ?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON