Chemical Engineering Mcqs

Prilling of urea should be accomplished (in a sprayer) just above the melting point of urea with minimum of retention time, otherwise it will result in__________________?

(A) Low bulk density product

(B) Biuret formation

(C) Non-spherical prills

(D) Substantially wet non-flowing and sticky product

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • D.C. windings are____________?
  • The high voltage winding is usually which of the following type ?
  • The flash point of transformer oil should be higher than_______________?
  • The usual values of maximum flux densities for distribution transformers using hot rolled silicon steel are______________?
  • For large power transformers, self oil cooled type or air blast type which of the following values of current density may be used?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON