Chemical Engineering Mcqs

Priming of a centrifugal pump is done to___________________?

(A) Increase the mass flow rate of fluid

(B) Develop effective pressure rise by the pump

(C) Avoid chances of separation inside the impeller

(D) None of these

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • A simply supported uniform rectangular bar breadth b, depth d and length L carries an isolated load W at its mid-span. The same bar experiences an extension e under same tensile load. The ratio of the maximum deflection to the elongation, is________________?
  • The strain energy due to volumetric strain________________?
  • The strain energy stored in a spring when subjected to greatest load without being permanently distorted, is called______________?
  • A spring of mean radius 40 mm contains 8 action coils of steel (N = 80000 N/mm2), 4 mm in diameter. The clearance between the coils being 1 mm when unloaded, the minimum compressive load to remove the clearance, is_____________?
  • The forces acting normally on the cross section of a bar shown in the given figure introduce_______________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON