Chemical Engineering Mcqs

The ratio of lateral strain to linear strain is termed as the___________________?

(A) Poisson’s ratio

(B) Bulk modulus

(C) Modulus of elasticity

(D) Shear modulus

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • If a bent tendon is required to balance a concentrated load W at the centre of the span L, the central dip h must be at least________________?
  • If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than________________?
  • Pick up the true statement from the following?
  • Pick up the incorrect statement from the following. The intensity of horizontal shear stress at the elemental part of a beam section, is directly proportional to__________________?
  • The width of the flange of a T-beam, which may be considered to act effectively with the rib depends upon____________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON