Chemical Engineering Mcqs

The velocity profile for a Bingham plastic fluid flowing (under laminar conditions) in a pipe is__________________?

(A) Parabolic

(B) Flat

(C) Flat near the wall and parabolic in the middle

(D) Parabolic near the wall and flat in the middle

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • A simply supported beam which carries a uniformly distributed load has two equal overhangs. To have maximum B.M. produced in the beam least possible, the ratio of the length of the overhang to the total length of the beam, is_________________?
  • To determine the force in BD of the truss shown in the given figure a section is passed through BD, CD and CE, and the moments are taken about________________?
  • A short column (30 cm × 20 cm) carries a load P 1 at 4 cm on one side and another load P2at 8 cm on the other side along a principal section parallel to longer dimension. If the extreme intensity on either side is same, the ratio of P1 to P2 will be_________________?
  • For beams breadth is constant__________________?
  • For calculating the permissible stress 0 y /[(1 + a(l/r)²] is the empirical formula, known as__________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON