Civil Engineering Mcqs

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • In a shell and tube heat exchanger, triangular pitch arrangement as compared to square pitch arrangement ?
  • _____________ heat exchanger is also known as ‘hair pin type’ exchanger?
  • The average velocity in the tubes of a 1-4 heat exchanger is ______________ times that in 1-1 heat exchanger having the same size & number of tubes and operated at same liquid flow rate ?
  • A shell may by termed as thin if its thickness to diameter ratio is less than 0.1. The factor which can be neglected in the calculation of membrane stresses is________________?
  • Fouling factor for a heat exchanger is given by (where, U1 = heat transfer co-efficient of dirty surface U2 = heat transfer co-efficient of clean surface) ?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON