Civil Engineering Mcqs

Minimum thickness of wall where single flemish bond can be used is_____________?

(A) half brick thick

(B) one brick thick

(C) one and a half bricks thick

(D) two bricks thick

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Under conditions of equal reduced pressure and equal reduced temperature, substances are said to be in the ‘corresponding states’. At equal reduced conditions i.e., at the corresponding state, the ____________ of different gases are nearly the same?
  • At 100°C, water and methylcyclohexane both have vapour pressures of 1 atm. Also at 100°C, the latent heats of vaporisation of these compounds are 40.63 kJ/mole for water and 31.55 kJ/mole for methylcyclohexane. The vapour pressure of water at 150°C is 4.69 atm. At 150°C, the vapour pressure of methylcyclohexane would be expected to be_________________?
  • The boiling points for pure water and pure toluene are 100°C and 110.6°C respectively. Toluene and water are completely immiscible in each other. A well agitated equimolar mixture of toluene and water are prepared. The temperature at which the above mixture will exert a pressure of one standard atm. is___________________?
  • Assume that benzene is insoluble in water. The normal boiling points of benzene and water are 80.1 and 100°C respectively. At a pressure of 1 atm, the boiling point of a mixture of benzene and water is__________________?
  • For an ideal gas, the compressibility factor________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON