Civil Engineering Mcqs

Ratio of permissible stress in direct compression and bending compression is______________?

(A) less than 1

(B) between 1 and 1.5

(C) between 1.5 and 2.0

(D) greater than 2

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Heat transfer by natural convection is enhanced in system with__________________?
  • Reynold’s analogy states that (where, St = Stanton number f = friction factor) ?
  • A dephlegmator is a_____________________?
  • Film boiling is usually not desired in commercial equipments, because____________________?
  • The advantage of backward feed multiple effect evaporators over forward feed units is that___________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON