Civil Engineering Mcqs

The sway bracing is designed to transfer____________________?

(A) 2Vi % of the top panel wind load to bottom bracing

(B) 10% of the top panel wind load to bottom bracing

(C) 25% of the top panel wind load to bottom bracing

(D) 50% of the top panel wind load to bottom bracing

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • With increase in moisture content of coal, its___________________?
  • In general, the limit of inflammability/explosion limit of fuel gases is widened by the__________________?
  • Traces of tar fog present in the coke oven gas is removed by_________________?
  • C/H ratio is the maximum in case of_________________?
  • Use of preheated air for combustion of fuel in the furnace, increases the___________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON