Mechanical Engineering Mcqs

A hydraulic intensifier normally consists of __________________?

(A) two cylinders, two rams and a storage device

(B) a cylinder and a ram

(C) two co-axial rams and two cylinders

(D) a cylinder, a piston, storage tank and control valve

(E) special type of pump with storage device and a pressure regulator

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Which of the following is the most common type of baffle used in industrial shell and tube heat exchanger ?
  • The clearance between two tubes in a shell and tube heat exchanger is known as ‘ligament’, whose minimum value is _____________ the outside diameter of the tube, but in no case it should be less than 4.5 mm?
  • A binary liquid Azeotropic mixture has boiling point lower than either of the components, when it shows _____________ deviation from Raoult’s Law?
  • Bubble cap diameter used for the distillation column having diameter ranging from 1.5 to 4.5 metres is about ______________ mm?
  • Optimum reflux ratio in a continuous distillation column is determined by the__________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON