Mechanical Engineering Mcqs

Impulse turbine is generally fitted______________________?

(A) at the level of tail race

(B) little above the tail race

(C) slightly below the tail race

(D) about 2.5 m above the tail race to avoid cavitation

(E) about 2.5 m below the tail race to avoid cavitation

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area ‘A’ is given by (where, P = perimeter of the channel in contact with the fluid) ?
  • The buckling tendency of compression members is always in the direction of the _____________________?
  • ____________ is the determining factor for the number of bubble caps to be used per tray?
  • Which of the following is the most common type of baffle used in industrial shell and tube heat exchanger ?
  • The clearance between two tubes in a shell and tube heat exchanger is known as ‘ligament’, whose minimum value is _____________ the outside diameter of the tube, but in no case it should be less than 4.5 mm?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON