Mechanical Engineering Mcqs

In a PERT chart___________________?

(A) all activities should be numbered

(B) only important activities should be numbered

(C) only critical activities are numbered

(D) only selected activities are numbered

(E) no activity is numbered

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • _______________ centrifuge is the most suitable for separation of non-friable crystals?
  • In a size reduction crushing operation, feed size is 300 to 1500 mm while the product size is 100 to 300 mm. This is a case of the ________________ crushing?
  • Higher is the mesh number, smaller will be the aperture size of the screen. It means that the aperture size of a 200 mesh screen will be smaller than that of 20 mesh screen. This is valid for__________________?
  • The most suitable filter for the removal of very small amount of precipitate from very large volumes of water is the _____________ filter?
  • Which of the following gives the crushing energy required to create new surface ?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON