Mechanical Engineering Mcqs

Reciprocating pumps are no more to be seen in industrial applications (in comparison to centrifugal pumps) because of____________________?

(A) high initial and maintenance cost

(B) lower discharge

(C) lower speed of operation

(D) necessity of air vessel

(E) all of the above

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • “A claming section” before the liquid flows into the downcomer is provided to__________________?
  • In sieve plate column, holes are drilled or punched in sizes ranging from 2.5 to 12 mm (5 mm being widely used). The hole pitch is normally ______________ times the hole diameter to give the required hole area?
  • The absorption factor is defined as (where, S1 = slope of the equilibrium curve, S2 = slope of the operating line) ?
  • Which of the following packing materials provides for maximum mass transfer ?
  • In a shell and tube heat exchanger having triangular pitch, the shell side equivalent diameter is given by________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON