Mechanical Engineering Mcqs

The ultimate tensile strength of low carbon steel by working at a high strain rate will_________________?

(A) decrease

(B) increase

(C) remain constant

(D) first increase and then decrease

(E) first decrease and then increase

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • Channelling is most severe_____________________?
  • When the liquid phase and vapour phase of a binary system obeys Raoult’s and Dalton’s law respectively, the relative volatility is the ratio of________________________?
  • Can a cooling tower cool water below the wet bulb temperature of inlet air ?
  • The rough value of diffusion co-efficient of water vapor into air at 25°C may be about ______________ cm2/sec?
  • In a distillation operation, what is the effect of the temperature of the reflux stream (given below) on the condenser and reboiler loads? Reflux conditions: (i) Reflux stream is completely liquid and is at its bubble point. (ii) Reflux stream is below its bubble point ?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON