Software Engineering Mcqs

When speaking of computer input and output, input refers to_________________________?

(A) any data processing that occurs from new data input into the computer

(B) data or information that has been entered into the computer

(C) the transmission of data that has been input into the computer

(D) both B and C

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • The open circuit voltage of a compound generator is 250 V. At full load the terminal voltage____________?
  • The terminal voltage of a series generator is 150 V when the load current is 5 A. If the load current is increased to 10 A, the terminal voltage will be____________?
  • A shunt generator can self-excite:_________________?
  • With a D.C. generator which of the following regulation is preferred ?
  • Two D.C. shunt generators, each with armature resistance of 0.02 ohm and field resistance of 50 ohm run in parallel and supply a total current of 1000 amperes to the load circuit. If their e.m.fs. are 270 V and 265 V, their bus bar voltage will be_____________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON