Software Engineering Mcqs

Which of the following is not a part of Execution Flow during debugging ?

(A) Step Over

(B) Step Into

(C) Step Up

(D) Step Out

Submitted By: Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • As load on an induction motor goes on increasing______________?
  • Slip ring motor is recommended where____________?
  • In an induction motor the relationship between stator slots and rotor slots is that_____________?
  • Low voltage at motor terminals is due to____________?
  • A 3-phase induction motor delta connected is carrying too heavy load and one of its fuses blows out. Then the motor______________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON